Specifications
Design-in guide Philips Fortimo LED Line High Voltage System 38
Installation instructions LED Line Cover 2ft soft-diffuse
Warnings!
Before installation, maintenance or cleaning, always switch off
or disconnect the power and follow the appropriate safety
procedures. Please review all warnings concerning the LED Line
in this design-in guide too.
Always assemble all five components of the Fortimo LED Line
Cover soft-diffuse to ensure a safe and reliable product. Follow
the assembly instructions as described in this design-in guide.
Make sure all components are securely fixed after assembly.
The diffuser prevents the live parts of the LED Line from
touching the back plate of the luminaire. For the stiffness of the
back plate of the luminaire, observe the design rule in this
design-in guide so as to guarantee safe use of the diffuser.
Do not use any damaged components.
Make sure the correct wiring is used (pages 29.). When fitting
the wires, guide them through the hole in the end cap so as to
ensure that they do not get damaged during assembly of the
end-cap components.
Place the end-caps at the right distance from each other, as
indicated by the hole pattern in page 35.
When parts (e.g. small boss end-cap bottom) break off or get
damaged during assembly, further assembly should be stopped.
The damaged parts should be replaced by new parts.
After fitting the diffuser or end-cap top the parts cannot be
removed without damage. Reworking the damaged parts is not
allowed for safety reasons.
The diffuser is provided with plastic foil, which has to be
removed before installation. Taking off this foil will create a
static charge. This means that installing engineers must be
earthed, just as when installing the LED Line. For further
information see the chapters „Warnings‟ and „Installation
instructions LED line‟.
Important
Once the diffuser and end-caps have been added, it is not
possible to open it again. This is so as to make sure that the
assembly will guard against high voltage in the end application.
Please review all instructions concerning the LED Line in this
design-in guide too.