Specifications

Design-in guide Philips Fortimo LED Line High Voltage System 34
Parasitic Current Protector
Parasitic Current Protector HV (PCP HV)
The LED‟s of the LED Linear HV products (LED Line and LED Strip) connected to a
TD Xitanium HV driver may glow (in the dark) when the driver is in stand-by mode.
Philips offers the Parasitic Current Protector HV (PCP HV) as a temporary solution.
The PCP HV is offered as a separate module (in a same housing as the linear HF-
Matchbox). Future generation drivers Xitanium HV non isolated linear office LED
drivers will have this solution integrated, so no separate module is needed anymore.
Decision tree for installing a PCP HV
Installing the PCP HV
LED drivers which can be used:
PCP HV must only be used in combination with HV non-isolated Xitanium TD Office
LED drivers with the following 10 NC numbers:
9290 006 847
9290 006 737
9290 006 704
9290 006 173
9290 006 618…622.
Connecting the PCP HV module between driver and LED Line
 Input cable of the PCP HV is the “Fortimo Solar LLM Driver 4500” (12nc 9290
006 15003, 7-pin JST connectors).
 Output cable is the original cable that was used between driver and LED module.
 Green wire serves as impedance matching to ground.
 Connect the green wire to the luminaire metal housing, using the fork terminal
for convenient fixation.
 Make sure that the green wire makes contact with the metal of to the luminaire
housing.
 Note that the length of the green wire can also be increased by the user
manually.
 Switch on LED driver and switch to standby mode
 Glow should be eliminated
 If not fully eliminated, switch off the system (disconnect from mains) and
disconnect the green wire. Switch on the system and check if the glow is
eliminated.