Specifications

Design-in guide Philips Fortimo LED Line High Voltage System 8
Cables to connect a LED Line to another LED Line
LED Line interconnecting cable
Cables are available in a variety of lengths to connect the LED Lines 3R with each
other (Board to Board (B2B)).
Cable
length
A
12 NC
LED Line cable 46 mm B2B
46 mm
9290 006 81603
LED Line cable 115 mm B2B
115 mm
9290 006 81703
LED Line cable 190 mm B2B
190 mm
9290 006 81803
Return-end cable
LED Line return cable
A „return-end‟ cable must be attached at the end of every chain of LED Lines to close
the circuit.
Return cable
Cable
length
A
12 NC
LED Line return-end cable HV
20 mm
9290 006 81503
Data for specific cable developed by OEM
We advise using the Fortimo LED Line cables. Approval of the LED Line and Xitanium
LED driver is based on a reference luminaire with the standard Philips cable of 60 cm.
Any luminaire design needs its own approval, organized by the responsible OEM,
irrespective of the length of cable used. If you prefer to develop a cable with a
different length, the specification should meet IEC/EN requirements. When selecting
wiring, it must be borne in mind that the cable must not emit hazardous gases or
catch fire when exposed to high temperatures (e.g. PVC-free)
The following cable/connector specifications can be used:
JST connector for cable to Xitanium 75 W LED driver:
- housing JST PAP-07V-S
- contact JST SPHD-001T-P0.5
- diameter of the cable: 24AWG
Molex connector for the module:
- crimp housing Molex 503473-0290
- crimp terminal Molex 503485-0100
Contact 1 = IDC white wire, connected to the “+” anode.
Contact 2 = NC not connected
Contact 3 = PGND yellow wire, connected to the “-“cathode.
Contact 4 = NTC optional to connect to the NTC on the LED board, if
available or to use MTP
Contact 5 = ISET1 optional to set current via Iset1, available on specific drivers
Contact 6 = ISET2 optional to set current via Iset2, available on specific drivers
Contact 7 = SGND Signal Ground for connections to pin 4, 5 and 6