Colour Television Operating Instructions

ManualsBrandsPhilips ManualsCRT TV21PT1323

Operating Instructions

21PT1323

21PT132321PT1323

Colour television

1-4_21PT1323/E 04/16/03, 5:20 PM1

Summary of content (23 pages)

PAGE 1
Colour television 21PT1323 Operating Instructions 1-4_21PT1323/E 1 04/16/03, 5:20 PM
PAGE 2
TABLE OF CONTENTS Introduction Safety Information/Useful Tips .................................................................................................. 3 Before Calling Service ................................................................................................................. 4 Basic Installation/Functions Hooking Up Your TV (Basic Connection) ............................................................................... 5 Use/Care of remote Control ..................................
PAGE 3
SAFETY INFORMATION AND USEFUL TIPS Safety Information Disconnect mains plug when : the red light below the TV screen is flashing continuously. a bright white line is displayed across the screen. cleaning the TV screen. Never use abrasive cleaning agents. Use a slight damp chamois leather or soft cloth. – there is a lightning storm. – the set is left unattended for a prolonged period of time. • – – – • No naked flame sources, such as lighted candles, should be placed on top of the TV or in the vicinity.
PAGE 4
BEFORE CALLING SERVICE Below is a list of frequently occurred symptoms. Before you call for service, make these simple checks. Some of these symptoms can easily be rectified if you know what to do. Symptom What you should do Colour patch (uneveness) • Switch off the TV by the mains power button. Wait for 20 minutes before switching on again. • Check the TV is not placed too near speakers or magnetic objects. No power • Check the TV’s AC power cord is plugged into the mains socket.
PAGE 5
HOOKING UP YOUR TV (BASIC CONNECTION) Antenna Connection • Connect the aerial plug to the antenna socket ¬ on the backcover. • Insert the mains plug into the wall socket. Mains Connection • For correct mains voltage, refer to type sticker at the rear of the TV set • Consult your dealer if mains supply is different. Note : This diagram is not representative of the actual plug and socket. Switching on the Set • Press the main power button to switch on/ off the TV.
PAGE 6
CONNECTING THE AUDIO/VIDEO SOCKETS (PLAYBACK) AV sockets on the rear of TV Back of VCR VCR (equipped with Video and Audio output sockets) You can view the playback of VCR tapes (Video Disc players, camcorders, etc.) by using the AUDIO and VIDEO INPUT sockets on the rear of the TV. – Connect the VIDEO and AUDIO IN sockets on the rear of the TV to the AUDIO and VIDEO OUT sockets on the VCR.
PAGE 7
FUNCTIONS OF REMOTE CONTROL & Power button – – Switch set off temporarily to standby mode. (The red light indicator lights up when the set is on standby mode). To switch on set from standby mode, press Channel +/– , Digit (0 -9) or Power button. é Personal Zapping buttons As Personal Zapping buttons, you can surf up to 10 personal channels for each button. For detailed description of functions, refer to section on “Personal Zapping ”.
PAGE 8
FUNCTIONS OF REMOTE CONTROL 2 A/V Button Allows you to select the AV channels. 3 Frownie button 2 3 4 5 6 7 8 Allows to delete stored personal preference channels in your Personal Preference list. For detailed description of functions, refer to section on “Personal Zapping ”. 4 Smart Picture Button Press the Smart Picture button repeatedly to access 5 different types of picture settings and choose your desired setting. 5 SAP Not Applicable.
PAGE 9
FUNCTIONS OF TV CONTROLS ➩ INSTALL MENU 3 – VOLUME + & 7 CHANNEL 6 ‘ ( é“ & Mains Power button Switch mains power on or off. é Standby light indicator Indicate red light when standby mode is activated. “ Remote Sensor Acts as a sensor for activating the controls of the TV when remote control handset is aimed at it. ‘ Volume + / – buttons Adjust sound volume softer/louder. ( Channel 7 / 6 buttons Select channel in descending/ascending order.
PAGE 10
SELECTING THE MENU LANGUAGE Operating instructions generally explains the operation of the TV set using the buttons on the remote control unless otherwise stated. Please read the following instructions carefully and follow the steps as shown to familiarise yourself with the installations and all features available in your set. Note: When there is no signal input to the TV, you may encounter instability of the on screen display.
PAGE 11
AUTOMATIC TUNING OF CHANNELS Automatic tuning of channels allows you to store each programme automatically. Step Press button Result on screen Enter main menu. Main ✔ Picture ■ Sound ■ Features ■ Install o π Brightness Colour Contrast Sharpness Colour Temp. More... œ Press button repeatedly until Install is selected.
PAGE 12
MANUAL TUNING OF CHANNELS Manual tuning of channels allows you to select your preferred channel number for every available programme. Step Press button Result on screen Main ✔ Picture ■ Sound ■ Features ■ Install Enter main menu. o π Brightness Colour Contrast Sharpness Colour Temp. More... œ ¸ Press button repeatedly until Install is selected.
PAGE 13
MANUAL TC UNING HANNELS OF CHANNELS Step Press button Start manual searching. Searching stops once a transmitting signal is found. ˙ ¸ 9 1 4 7 10 11 12 2 5 8 0 Result on screen Select Channel. Key in the channel number. 3 6 9 Press button repeatedly until Store is selected. ¸ Store tuned channel. Note : If you want to continue searching for another transmitting channel, repeat steps 7 to 11.
PAGE 14
SELECTING THE COLOUR/SOUND SYSTEM This feature allows you to select your desired Colour and Sound system. If Auto is selected, the respective colour and sound system will be automatically selected according to the transmission system. Note : Select your desired colour and sound system manually if reception is poor at Auto mode. Step Press button Result on screen Repeat step 1 to step 5 as in “Manual Tuning of TV Channels” Colour System is selected.
PAGE 15
FINE TUNING OF CHANNELS This feature allows you to adjust picture reception in areas of weak reception. Step Press button Result on screen Enter main menu. Main ✔ Picture ■ Sound ■ Features ■ Install o π Brightness Color Contrast Sharpness Colour Temp. More... œ ¸ Press button repeatedly until Install is selected. Main ■ Picture ■ Sound ■ Features ✔ Install o Language Auto Store Manual Store Sort Channel Edit π œ ˙ Enter install menu. Press button repeatedly until Manual Store is selected.
PAGE 16
EDITING OF CHANNELS This feature allows you to skip or edit channels which have bad or weak TV signal or channels that you do not watch often. Note : Once a channel is skipped, you cannot have access to it by the CH (Channel) + or – button.You can only have access to the channel by the Digit (0 -9) buttons. Step Press button Result on screen Enter main menu. Press button repeatedly until Install is selected.
PAGE 17
ADJUSTING THE TV PICTURE The picture menu allows you to make adjustments to the picture. Step Press button Result on screen Display the main menu on screen. ˙ ˚ Enter Picture menu. Select item. or ¸ ˝ or Adjust level or select desired setting. ˙ m o π Brightness Colour Contrast Sharpness Colour Temp More...
PAGE 18
ADJUSTING THE TV SOUND The sound menu allows you to make adjustments to Auto Volume leveller (AVL). This feature enables volume to remain at a pre-determined level should there be a sudden change in volume during commercial breaks or channel switching. Step Press button Result on screen Display the main menu on screen. ¸ Select Sound menu. Main ✔ Picture ■ Sound ■ Features ■ Install o π Brightness Colour Contrast Sharpness Colour Temp. More...
PAGE 19
USING THE SCREEN FORMAT You can have a choice of two formats for your viewing pleasure, namely : - 4:3 mode and the EXPAND 4:3 mode through the FORMAT menu. Step Press button Result on screen Display the main menu on screen. ¸ Press button repeatedly until Features is selected. Main ■ Picture ■ Sound ✔ Features ■ Install o Format π œ ˙ ¸ ˙ m Enter the Features menu. Feature ✔ Format 4:3 π Press button repeatedly until Format is selected.
PAGE 20
SMART PICTURE CONTROL Whether you are watching a movie or video game, your TV has automatic video control settings matched to your current program source or content. The Smart Picture feature quickly resets your TV’s video controls of program for a number of different types of programs and viewing conditions you may have in your home. Each Smart Picture setting is preset at the factory to automatically adjust the TV’s Brightness, Colour, Picture and Sharpness levels.
PAGE 21
PERSONAL ZAPPING A list or series of favourite TV programs can be selected and stored in the 4 coloured buttons with the Personal Zapping feature. With this feature you can easily viewed up to a total of 10 preferred channels for each coloured button. Adding Channels to the Favourite list Step Press button 1 4 7 2 5 8 0 3 6 9 Result on screen Select a channel by the Digit buttons 8 Press button to display list. 8 Choose your favourite colour button to store selected channel.
PAGE 22
SPECIFICATIONS 21PT1323 Picture tube screen size 540 mm Picture tube visible area 510 mm Audio Output : Speaker 1x4 W Sound System Mono Playback System NTSC 3.58, NTSC 4.43, PAL 60 Set Dimensions : Width Depth Height 600 mm 487 mm 458 mm Net Weight of Set (approximate ) 25 kg Version 56 67 Transmission System NTSC (3.58-4.5) (4.43-5.5) (4.43-6.5) (3.58) (4.
PAGE 23
3141 055 21402 23 22-23_21PT1323/E 23 09/29/03, 11:07 AM