Specifications

16. Once all the bolts are inserted, apply the fender washers and hand-tighten with
the nuts. (See Fig. 17a) AGAIN, do not tighten in a circular pattern.
17. Tighten all 20 nuts and bolts in a criss-cross pattern to opposite corners, as per
the Fig. 17a. Tighten until snug. (See Fig. 17b)
Fig. 17a Fig. 17b
NOTE: The PSI of the water running through this part of the 150 PE
is extremely LOW. Because of that, and because of all the grease you
have applied, you do not need to tighten the bolts beyond what is
snug. Leave no more than 1/8 of the thread of the bolt exposed, as
shown in Fig. 17c.
Fig. 17c