Specifications

13. Place the Top (lid) on top of the gasket, and align the front of the Top Assembly
to the RK2 insignia as shown in Fig. 13.
14. Use a Phillips screwdriver to align the holes around the Top, through the
gaskets, and cone to the Reaction Chamber.
Fig. 13 Fig. 14
15. Position the 5/16” x 3/4” standard flat washers and insert the 2 1/4” bolts into
the 20 holes.
HELPFUL HINT: Initial bolt insertions may be more challenging
than subsequent ones. It is preferable to thread all bolts through the
holes rather than using a hammer or other implement to pound
them through.
WARNING: At this point you may be tempted to apply the fender
washers to the bottoms of the bolts and begin tightening them in
a circular pattern around the top. TRUST US: If you do one side at
a time, or go in a circular pattern, the result will be that one side
rises too high, unequal pressure will result, and the acrylic material may
fracture.