Specifications

6
TPF1.3A LA
4. Mechanical Instructions
Front view
Back view
Step 1. Remove the stand.
Remove the three screws as Fig.2,Fig.3
Fig.3
Fig.2
Fig.1
Step 2. Remove the Back cover as Fig.4~7.
a.
b. Use thin "I" type screwdriver to push 2 clicks on bottom
side and use thin type screwdriver to open the bottom side as Fig.5
c.
Remove the 4 screws on the back cover as Fig.4
"I"
Use thin "I" type screwdriver to push 2 clicks on top
side and use thin "I" type screwdriver to open the top side as Fig.6
d. Remove the back cover as Fig.7.
Fig.6
Fig.7
Fig.8
Step 4. Remove the YPbPr-IN,Scaler, KEY ,IR and inverter board.
a).Remove the 2 screws and disconnect the 10 cables as Fig. 10
to remove the YPbPr-IN board.
b).Remove the 4 screws and disconnect the connector as Fig.11
to remove the scaler board.
c).Remove the 2 screws and disconnect the connector as Fig.12
to remove the inverter board.
d).Remove the screw and disconnect the connector as Fig.13 to
remove the IR board.
Fig.9
Fig. 10
Fig.4
Fig.5
4. Mechanical Instructions
Index of this chapter:
4.1 Assy/Panel Removal
4.2 Set Re-assembly
4.1 Assy/Panel Removal
Step 3: Remove the shielding
a. Remove the 4 screws as Fig.8 Fig.9
b. Remove the shielding as Fig.10
[url=http://www.hqjdw.com/register.php?fromuser=乖乖狗]
红旗家电维修论坛，游客都可以下载资料[/url]
乖乖狗制作，严禁转载
http://www.hqjdw.com/?fromuid=乖乖狗