Specifications

48
TPF1.3A LA
4). Click (Write EDID) icon from the tool bar to write DDC data.wait
for 5 seconds ,DDC data will be finished Writing.
Fig. 24
3) Push Menu to exit OSDmenu.""
Fig. 22
8. Click Next , bring up Fig. 22.
- Click Finish to exit the Step window.
- Serial number can be filled up at this moment (for example,
923418).
Step 5: Write DDC data
1. Configuration should be as Fig. 23. And press OK.
Fig. 23
2. Click Save.
Step 7: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 26.
Step 6: Save DDC data
Sometimes, you may need to save DDC data as a text file
for using in other IC chip. To save DDC data, follow the
steps below:
1. Click (Save) icon (or click "file"-> "save as") from the tool
bar and give a file name as shown in Fig. 25.
The file type is EDID46 file (*.ddc) which can be open in
WordPad. By using WordPad, the texts of DDC data & table
(128 bytes, hex code) can be modified. If DDC TEXTS &
HEX Table ar completely correct, it can be saved as .ddc flie
to re-load it into DDC IC for DDC Data application.
Fig. 26
Step 8: Turn off the monitor, exit the factory mode.
Fig. 25
Factory Mode
Indicator
----------------->
2. Access Factory Mode
1). Turn off monitor.
2).
3). Press "MENU" button, wait until the OSD menu appears
(See Fig.24).
Press power " " button.Then quickly push"+"and"-"of
Volume ,and hold this two buttons , then the screen comes out
"Waiting For Automatic Adjustment ",then the screen will be black
for one second untill comes out "Windows screen"] => then
release this two buttons.
8. Alignments
20TA1000
20TA1000 analog
Serial NO. definition
[url=http://www.hqjdw.com/register.php?fromuser=乖乖狗]
红旗家电维修论坛，游客都可以下载资料[/url]
乖乖狗制作，严禁转载
http://www.hqjdw.com/?fromuid=乖乖狗