Specifications

1. Technical Specifications,Connections,and Chassis Overview
2
1.Technical Specifications,Connections,and Chassis Overview
TPS 1.0A LA
1.1 Technical Specifications
1.1.1 Technical Specifications
Index of this chapter:
1.1 Technical Specifications
1.2 Connections
1.3 Chassis Overview
Notes:
Figures below can deviate slightly from the actual situation,
due to the different set executions.
Specifications are indicative (subject to change)
Panel :CPT
Display area(mm) : 408.0mm (H) x 306.0mm (V)
Number of Pixels : 640x3 (H) x 480 (V)
Pitch ( mm ) : 0.6375mm (H) x 0.6375mm (V)
Color pixel arrangement: RGB vertical stripe
Display operating mode : Normally White, TN
Color depth : 16.2M colors ( 6Bit+FRC)
Brightness (cd/m^2) : 450 nits (Typ.)
Viewing angle(CR>10) : Viewing angle free(R/L 160
(Typ.),U/D 135(Typ.))
Surface treatment : Hard coating 3H; Anti-glare
Electrical interface : TTL
Response Time : 8ms (Typ)
Contrast ratio : 500 (Typ)
Outline Dimension : 448.0 mm(W) x 347.0 mm(H)
x 23.0(D) mm (Max)
Module weight (g) : 3800(Typ.)
Backlight : 6 CCFLs, side-lighting
Support video format : 1440x480i/59Hz
1440x480i/60Hz
1440x576i/50Hz
720x480p/59Hz
720x480p/60Hz
720x576p/50Hz
1440x480p/59Hz
1440x480p/60Hz
1440x576p/50Hz
1280x720p/50Hz
1280z720p/59Hz
1280x720p/60Hz
1920x1080i/50Hz
1920x1080i/59Hz
1920x1080i/60Hz
1920x1080p/50Hz
1920x1080p/59Hz
1920x1080p/60Hz
1.1.2 Sound
Sound systems : Mono / Stereo / Virtual Surround
Maximum power : 2 x 3W
1.1.3 Miscellaneous
Ambient conditions
Temperature : 0 to40°C
Humidity : 20 to 70% (non --condensing )
Power Supply
AC-input : 90V ~ 264VAC, 50/60±3Hz
Power consumption:
Normal:
1. PC Mode: TYP 60 W (with audio)
2. TV Mode: TYP 60 W (with audio)
Maximum: 65W (with audio)
Power cord length : 1.8M
Power cord type : 3 lead with earth plug, pluggable
Power indicator : LED (On: Blue, Standby mode: Amber)
Auto power saving : VESA DPMS
Power consumption
Normal: 60W/Typ. at PC mode, 60W /Typ.
at TV mode (LED: Blue)
Max: 65W(with Audio)
Standby < 2W (Amber)
DC power switch off < 2W
1.2 Connectors
1.2.1 I/O interface
Connectors: From Right to Left
1. Compair
Rx/Tx communication
2. Tuner: PAL D/K for /93 (China model)
PAL B/G
I and SECAM B/G D/K for /98 (AP model)
PAL D/K
I and NTSC-M for /79 (AP model)
3. ITV-Level 1: ITV Level 1 connector (4-pin connector)
4. Comp IN : Component input with YPbPr format with audio R/L.
5. PC audio IN: audio R/L(mini-jack).
6. PC IN: VGA input (D-SUB connector)
7. DVI-D : digital PC and video input
Vertical Connectors at the right side
1. Earphone : earphone jack
2. SIDE AV audio IN : AV and S-Video shared audio R/L (RCA jack)
3. SIDE AV IN : Composite video input (SIDE AV)
1.2.2 Electrical characteristics of I/O
PC Signal type
a. Analog Video : 15pin D-Sub,0.7 Vp-p linear, positive polarity and
Separate Sync( TTL level,positive or negative polarity)
b. Digital Video : 24-pin DVI-D connect connector, Single TMDS link according
to DVI 1.0 specification w/ High-Definition Content Protection
(HDCP) Specification 1.10
c. Audio signal : Mini-jack audio input,
Level: Nominal : 0.5 V rms.
- Maximum : 1.5 V rms.
-Impedance > 10 k
TV mode signal type
RF Signal : Aerial input / 10mV(30-100dBuV)
Video signal : CVBS input(RCA jack) / 1Vpp (300mV-sync, 700mV-video.)
S-Video input / 1VppY-signal, +/-300mV C-signal
COMP Video(YPbPr input)/ 1Vpp Y signal, +/-350mV Pb,Pr signal
DVI/Digital interface with 4 channels TMDS signal and
compatible with HDMI1.1 requirements except audio portion.
CVBS output (RCA jack) / 1Vpp (300mV-sync, 700mV-video.)
Audio signal : Audio (1) R/L for SIDE AV IN (AV and S-Video).
Level: - Nominal : 0.5 V rms.
-Maximum :1.5Vrms.
- Impedance > 10 k.
Audio (2) R/L for Comp Video IN.
Level: - Nominal : 0.5 V rms.
-Maximum :1.5Vrms.
- Impedance > 10 k
Audio (3) Mini-jack audio for DVI
Main Speaker
Speaker output : 2 x 3 Wrms, with T.H.D. < 10%.
Headphone
Audio: R/L output -10mW at 32.
3.5mm stereo jack
Impedance is between 8 and 600