Operation Manual

Depart. Technical support- CM640 PROCEDURE COMPANY RESTRICTED

PHILIPS Consumer

Communications

Centre du Mans

Service Repair Support

VY-V-640-P162

Page : 21 of 38

Langue : EN

Date : 08/02/05

.3.1 Charger detection / Battery charging

Plug the transformer unit into an easily accessible AC po socket.

Insert the Test production Card in the mobile, plug a dummy Battery with a multimeter added (see picture) for

current measurement.

- Plug t arger (+5VDC 500mA m cket at the base of the transceiver. The

battery of charg

• a

If the battery i tes on y after being connected to

charger.

Just aft a pre-charge rved during conds

After fe current of 30

- Unplu

.3.2 Current consumption

) Check current_OFF :

.23

) Check Current_ON

- Turn the mobile on.

- Remove the battery.

- Gently slide the card out away from the Product

8.3 Battery Charging (IGN : Ignition) / Current consumption

- wer

he connector of the ch

symbol should indicate the state

ax.) into the right so

e :

Bars moving - means the b ttery is being charged.

Steady - means the b ttery is fully charged.

s totally discharged, the battery icon will start scrolling to 3 minu 2 l

er charger plugging

current 30 < I (mA) < 70 can be obse 2 or 3 se

w seconds a char 0 mA approx. has to be observed

g the charger

hen the mobile is OFF the current measured must be : 0.00 < I (mA) < 0

When the mobile is ON (backlight activated) the current measured must be :

220 < I (mA) < 260

This measurement has to be operated during first seconds after switch on.

BAT - BAT +

or in part is prohibited without the written