Technical data

DDC INSTRUCTIONS

Magnavox LCD TV

Go to cover page

Step 6: Save DDC data

Sometimes, youmay need to save DDC dataas a textfileforusing

inother IC chip. To save DDC data,follow the steps below:

1. Click (Save) icon (or click "file"-> "save as") fromthetoolbar

And give a file name asshown in Fig. 24.

The file type is EDID45 file (*.ddc) which can be open in W

ordPad.

By using WordPad, the texts of DDC data &table (128 bytes, hex

code) can be modified. If DDC TEXTS &HEXTable are completely

correct, it can be saved as .ddc flie to re-loaditinto DDC IC for DDC

Dataapplication.

2. Click .Save

Step 7: Exit DDC program

Pull down the File menu and select Exit asshown in Fig. 2

Step 5: Write DDC data

1. Configuration should be asFig. 23.AndpressOK.

3. Click (Write EDID)icon fromthetoolbarto write DDC data.

Bring up "Writing 0%~100%, ready" a progressing bar on the left

down corner.

4. Turnoff/on monitor

Fig. 23

Fig. 25

Fig. 24

150S5-DDC

C:\Mydocuments\150F1-DDC

150F1-DDC

Access factory. Mode

Step1:Select the source "PC" andthen turnoff LCD-TV.

Step 2 : [Push "power " button andthen push the "VOL-"and"VOL+"

buttons atthesame time immediately andhold it] about fiveseconds

then release all buttons.

Press "menu"button andbring up factory mode indication