Technical data

34
150MT10P LMT
Go to cover page
DDC Instructions (Continued)
3. To match with the serial number modification on EEprom(OSD)
See page 116~117.
Fig. 26
Fig. 27
Fig. 28
Step 8: Save DDC data
Sometimes, you may need to save DDC data as a text file for using
in other IC chip. To save DDC data, follow the steps below:
1. Click (Save) icon (or click "file"-> "save as") from the tool bar
and give a file name as shown in Fig. 26.
The file type is EDID30 file (*.ddc) which can be open in WordPad.
By using WordPad, the texts of DDC data & table (128 bytes,
hex code) can be modified. If DDC TEXTS & HEX Table are completely
correct, it can be saved as .ddc flie to re-load it into DDC IC
& EEPROM for DDC Data application.
Step 9: Load DDC data
1. Click from the tool bar.
2. Select the file you want to open as shown in Fig. 27.
3. Click Open.
2. Click Save.
Step 9: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 28.
Step 5: Access Factory Mode for DDC data writing
Factory Mode:
How to Get into Factory Mode Menu
Push Menu " " & " " & " " buttons simultaneously
untill picture comes on the screen.
Press Menu " " button, bring up Factory mode indication as
shown in Fig 23 .
OK ATUO
OK
Step 6: Write DDC data
1. Click (Write EDID) icon from the tool bar to write DDC data.
(0% ~ 100%, -> READY)
2. Click (Read EDID) to re-confirm it.
Factory Mode
Step 7: Reconfirm Monitor Serial Number in User Mode
1. Go back to USER Mode as shown in Fig. 24 :
Turn off monitor, then turn on monitor again => leave factory mode
and return to User Mode directly.
2. Select "Product information" => Press "OK" button
=> Bring up Fig. 25.
User Mode
Fig. 23
Fig. 24
Fig. 25
150MT10P
150MT10P.DDC
150MT10.DDC
PRODUCT INFORMATION
SERIAL NO. : TY 888888
RESOLUTION : 720 X420 @70HZ
OK BACK TO MAIN CONTROLS
==>