Specifications

Mechanical Instructions

EN 8 TE3.2E CA4.

4. Mechanical Instructions

Index of this chapter:

4.1 Rear Cover Removal

4.2 Service Position Main Panel

4.3 Rear Cover Mounting

Note: Figures below can deviate slightly from the actual

situation, due to the different set executions.

4.1 Rear Cover Removal

• Remove all (ten) fixation screws of the rear cover: two at

the top, two at each side, three at the bottom and one in

the middle of the rear cover. The 14" set has only four

fixation screws: two at the top and two at the bottom.

• Now pull the rear cover backward to remove it.

4.2 Service Position Main Panel

• Disconnect the strain relief of the Mains cord.

• Remove the main panel, by pushing the two centre clips

outward [1]. At the same time, pull the panel away from the

CRT [2].

• Disconnect the degaussing coil by removing the cable from

connector KP02.

• Move the panel somewhat to the left and flip it 90 degrees

[3], with the components towards the CRT.

4.3 Rear Cover Mounting

Before you mount the rear cover:

• Place the mains cord correctly in its guiding brackets

(strain relief).

• Place all cables in their original position.

Figure 4-1 Mechanical Service Position

G_16010_010.eps

130206