Specifications

Directions for Use
EN 6 L03.2U AA3.
3. Directions for Use
Cable Box Connections
2
TO
TV/VCR
CABLE
IN
IR
USB
DVD-D OUT
AUDIO IN
SPDIF
VIDEO
IN OUT
S-VIDEO
R L
AUDIO OUT
TV
PASSCARD
Y Pb Pr
OPTICAL
SPDIF
1
2
751
751
3
Jack Panel Back of Cable Box
Cable Signal IN from the Cable
Company
Round 751
Coaxial Cable
Jack Panel Back of TV
I
f you cable signal uses a cable box or decoder, follow the easy steps below to
complete the connection. Cable Box (w/RF In/Outputs):
This connection will be mono. 1
Connect the Cable Company supplied cable to
the signal
IN(put) plug on the back of the Cable Box.
2
Using a separate round coaxial cable, connect one end to the OUT(put) (TO TV) plug on
the back of the Cable Box.
3
Connect the other end of the round coaxial cable to the 751 input on the back of the television. Screw it down finger tight.
NOTE: If applicable, set the OUTPUT CHANNEL SWITCH on the back of the cable box to CH 3 or 4. Tune the TV to the same channel and change channels at the cable box. In some cases, the cable box will automatically tune to either channel 3 or 4, change channels until the picture appears.
If no Video Signal is present, the TV will display a “BLUE” screen and shut itself off in about 5 minutes. If the TV is tuned to the AV channel and there is no Video Signal present, the screen will remain black and the TV will shut itself off in about 5 minutes.
Helpful Hints
I
f Cable TV signal into your home is a single cable (75 ohm) the connection
to the TV is easy.
1
Connect the Cable TV cable directly to the 751 jack on the TV.
Basic Cable TV Connection
Basic Antenna Connection
751
751
Cable TV Signal
RF Coaxial
Cable 751
Rear of TV
A
combination antenna receives normal broadcast channels (VHF 2-13 and
UHF 14-69). Your connection is easy since there is only one 751 (ohm) antenna plug on the back of your TV - and that’s where the antenna goes.
1
If your antenna has a round cable (75 ohm) on the end, then you're ready to connect it to the TV. Go to step 2. If your antenna has flat twin- lead wire (300 ohm), you first need to attach the antenna wires to the screws on a 300 to 75 ohm adapter (not supplied with TV).
2
Push the round end of the adapter or antenna cable onto the 751 jack on the rear of the TV. If the round end of the antenna cable is threaded, screw it down tight.
1
751
751
Combination
VHF/UHF Antenna
(Outdoor or Indoor)
Twin Lead
Wire
Round Cable 751
Rear of TV
If no Video Signal is present, the TV will display a “BLUE” screen and shut itself off in about 5 minutes. If the TV is tuned to the AV channel and there is no Video Signal present, the screen will remain black and the TV will shut itself off in about 5 minutes. Use Auto Program as described on panel 9 to set up channels that are available in your area. Use the CH +/– buttons to scan available channels.
Helpful Hints