User manual
8
• Adjust the installation angle of the central plate.
(1). If the stops of the existing halogen lamp is vertically up
and down, it is not required to adjust the installation
angle of the central plate. Otherwise, it is required
to adjust the installation angle of the central plate for
the LED-HL [≈H11] lamp.
(2). Use the Allen key to loosen the three set screws of
the central plate as is shown below.
(3). Turn the central plate until the LED burner is aligned
vertically in the reector, the LEDs shining to the left
and the right, as shown on below picture. (see the
hollow arrows in the following gure) and that the
LED shines toward the right and the left sides of the
reector. Then, fasten the screws for the central plate.
Illumination
orientation of
the left LED
Illumination
orientation of
the right LED