User manual
(3).Turn the central plate until the LED burner is
aligned vertically in the reector, the LEDs shining
to the left and the right, as shown on below picture.
(see the hollow arrows in the following gure) and
that the LED shines toward the right and the left
sides of the reector. Then, fasten the screws for
the central plate.
11
• Adjust the installation angle of the central Ring
(1).
If the stops of the existing halogen lamp is vertically
up and down, it is not required to adjust the
installation angle of the central plate. Otherwise,
it is required to adjust the installation angle of the
central Ring for the LED-HL [=HIR2] lamp.
(2).Use the Allen key to loosen the three set screws
of the central Ring as is shown below.