User's Manual

Video cable
Connecting the Video Cable:
The monitor comes with a built-in video
cable. Plug the signal cable's 15-pin connector into the computer's video port
and tighten the two screws on the cable connector.
Caution:Don’t bend the signal cable, otherwise it will break the inner wire.
Connecting the Power Cord: Plug the power cord into the monitor’s AC
power jack. Then plug the power cord into the power output socket on your
PC.
Caution:
If the AC outlet is not grounded, install the proper grounding
adapter (not supplied).
Signal Cable
Figure 2 Connecting Cables
OPERATING INSTRUCTIONS
General Instructions
The power switch is located at front panel of the monitor. Press the power
switch to turn the monitor on or off. The other control knobs are located at
the base of the monitor (See Figure 3). By changing these settings, the picture
can be adjusted to your personal preferences.
•
The power cord should be connected.
•
Connect the video cable from the monitor to the video card.
•
To turn the monitor on, press the POWER switch to ON position. The
power indicator will light up.
•
Your monitor features a unique quick switch system which provides a
picture within seconds after the monitor is switched on.