User's Manual

RETURN TO TOP OF THE PAGE
Federal Communications Commission (FCC) Notice (U.S. Only)
z
Reorient or relocate the receiving antenna.
z
Increase the separation between the equipment and receiver.
z
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
z
Consult the dealer or an experienced radio/TV technician for help.
Use only RF shielded cable that was supplied with the monitor when connecting this monitor to a computer d
e
To prevent damage which may result in fire or shock hazard, do not expose this appliance to rain or excessiv
e
THIS CLASS B DIGITAL APPARATUS MEETS ALL REQUIREMENTS OF THE CANADIAN INTERFERENC
E
EQUIPMENT REGULATIONS.
RETURN TO TOP OF THE PAGE
software. From indicated inactivity to Power Saving Position A2, the total time must not be set
to more than 70 minutes.
NUTEK VESA State LED Indicator Power Consumption
Normal operation ON Green 68 W (typical)
Power Saving
Position A1
Suspend Blinking Green < 2 W
Power Saving
Position A2
OFF Blinking Green < 2 W
A
s an
E
NERGY
S
TAR
®
P
artner,
PHILIPS
has determined that this
product meets the
E
NERGY
S
TAR
®
guidelines for energy efficiency.
We recommend you switch off the monitor when it is not in use for quite a long
time.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.