User's Manual

PHILIPS WLAN Configuration Utility & User Manual
PHILIPS COMPONENTS
Page 11
2.3 APPLICATION / MOUNTING NOTES
MOUNTING OF THE MODULE BOARD
1. After confirming that the front and back side of module boards are correct,
insert the module board at an angle of 20° to 30° into the innermost part of the
connector.
2. Pushing down the module board downwards, when load is kept applied,
the latches at both sides will be turned on. The total mating force should not
exceed 51.5 N.
3. If the module board is held by the latches and does not get up, mounting
will finish.