User's Manual

3-11
3-2.3.2.2 Add a Specific Class & Type of Remote Device
The following steps add a filter that results in only remote devices that are a specific class
and type being displayed in the Bluetooth Neighborhood window:
1. Open the Configuration window. The General tab is displayed.
2. Click the
Discovery tab.
3. Click the down-arrow located at the right end of the filter field (Figure 6-A)
and select the Report only Selected Bluetooth devices option from the
drop-down list.
4. Click the Discovery tab Add Device button (Figure 6-B). The Discoverable
devices... dialog box is displayed.
5. Check the radio button labeled
Allow this computer to discover specific
classes or types of devices within a class to select it (Figure 6-C).
6. Click the down-arrow located at the right end of the Class field (Figure 6-D)
and select a class from the drop-down list. The available classes and the default
type, which is automatically selected, are listed in Table 1.
NOTE: If the device type within a class has more than the
one option, the default is the first selection in the
drop-down list.
Table 1: Discovery tab > Class and Type of Device Options.
Class of Device and Type of Device Options
Class of Device Type of Device
Desktop Workstation (default)
Server Class Computer
Laptop
Handheld PC/PDA
Palm PC/PDA
Computer
All
Cellular (default)
Cordless
Smart Phone
Wired Modem or Voice Gateway
Phone
All
LAN Access Point
All (default)
Headset (default)
Audio
All
Peripheral
All (default)
7. To change the Type field, click the down-arrow located at the right end of the
field (Figure 6-E) and select a type from the drop-down list.
8. Click the dialog box OK button (Figure 6-F). The selected device class and type
will appear in the filter list on the Discovery tab.
9. Click the Configuration window Apply or OK button (Figure 5-F).
Repeat the Add Device process to select and add additional, remote device classes and
types to the filter list.