User's Manual

3-5
3-2 Configuration
This section describes the BTW Bluetooth Configuration window and the settings that
can be changed on the eight tabs that comprise the window.
To activate changes made on the Configuration window:
x Click the OK button located on the bottom of the Configuration window to apply
the changes and close the window.
OR
x Click the
Apply button located on the bottom of the Configuration window to
apply the changes and leave the window open.
To throw out any changes and close the window:
x Click the Cancel button located on the bottom of the Configuration window.
OR
x Click the close button 7
77
7 located in the upper-right corner of the
Configuration window.
3-2.1 GENERAL TAB
Device properties and system security are configured in the General tab which is shown
in Figure 1 on page 2.
3-2.1.1 Computer Name and Type
In the Identity section of the General tab, the Computer name field identifies your
computer to other Bluetooth devices. This is user-configurable and is different from the
Bluetooth Device Address (BDA) set at the factory. The BDA is shown on the Hardware
tab. The Computer name is the name entered during the BTW installation process.[LTS2]
The Computer name field cannot be left blank. However, it should be understood that
some Bluetooth devices might only list your computer by its BDA.
To change the Computer name:
[LTS3]
1. Open the Configuration window. The General tab is displayed.
2. The current Computer name is highlighted. Type a new name. The old name is
deleted once you begin to type.
 A valid Computer name is between 1 and 247 characters, for example,
My Laptop.
3. Click the Configuration window
Apply or OK button.
The Computer type assigns your computer’s device type as either Desktop or Laptop. The
device type information is made available to remote devices when these are discovering
other Bluetooth devices. Desktop is the default setting.
To change the Computer type:
1. Open the Configuration window. The General tab is displayed.
2. Click the down arrow located at the right end of the Computer type field and
choose
Desktop or Laptop from the drop-down list.
3. Click the Configuration window Apply or OK button.