User's Manual

PTZ: You may control pan/tilt/zoom mechanism that is connected on Cam if the pan/tilt and
zoom lens are installed. However the drivers for the pan tilt and zoom must be installed in to
the communication protocol in the Cam to control pan/tilt/zoom mechanism.
If PTZ mechanism is connected to Cam, press ‘Setup’ button and configure the followings:
Model: For now, Cam is equipped with some protocols for specific models of pan/tilt
mechanisms. Administrator selects a communication protocol from a pre-set list of attached external
device. Philips has listed protocols of KukJae (KRS-3200), Philips (AutoDome and TC8560X-4), Pelco
(P and D), Sony (EVI-D3x), Video Technical (VTP-4x), Sensormatic, SungJin, Samsung, LG, Lilin, etc.
Administrator may utilize any pan/tilt mechanism that satisfies already listed protocols. The
communication protocols vary for each manufacturer. So it is recommended to buy a pan/tilt
mechanism among registered ones.
Interface: Cam has two pairs of interface pins; the RS232 interface and the RS485 (Half-Duplex)
interface. It is to select a proper interface with which a pan/tilt/zoom control receiver is connected to
Cam.
Baud: Configures data transmission rate.
Parity: Checks data loss for transmission.
Stop bit: Configures stop bit for transmission.
Data bit: Configures data bit for transmission.
Address: This menu identifies the base address for a video channel and a pan/tilt/zoom (P/T/Z) control
receiver. The Cam may support up to four P/T/Z devices for four separate channels when 485 interface,
(RS485 Half-Duplex) is enabled. The “Address” identifies each P/T/Z device to each channel. Select a
channel to configure and change the “Address” to correspond with the channel number. This will allow
independent operation, up to four P/T/Z controls. In addition, all channels can be set to the same
“Address” for synchronized movement.
External Device: If you want to utilize external sensors for digital input ports or electric lights at a digital
output port, check the relevant items in the bottom of this tab. In this case of sensor, be cautious that Cam
is set to support normal closed (NC) type sensors only. In this menu, you configure which external device
is utilized. The detail items of relevant external device are configured in Schedule tab. With ‘digital
output’ button, you may utilize ‘digital output’ function and monitor real-time image simultaneously.