User's Manual

7) Setting Channel information
This is to configure channels and PTZ / external device according to each channel.
Channel Use: This is to select
channels to see live images and to
record them on Cam’s self-contained
HDD. For example, when you
connect an external CCD camera to
Ch1 port in the rear of Cam, select
‘External’ for Channel 1. However
when you don’t want to utilize
channel 1, select ‘None’ for Channel
1. You can also select one or more
channels as a video source. For
external channels, it is very
important you check only the
channels that are connected with an
external camera. Otherwise recording
speed or transmission speed may be
lower.
Camera Config: In this step, you define external CCD cameras between ‘NTSC’ and ‘PAL’ and
decide whether to rotate image by 180 or not. If you rotate image that is sent from each
cameras, you do not need to place any bracket to place Cam or external cameras to capture
images at right angle. You just place directly on the ceiling by upside down. And when you
use black & white camera, you should check B&W.
MD THR: Through ‘MD THR’ panel, you may set sensitivity of motion detection. The range is from 1 to
999. ‘1’ is the highest level, and ‘999’ is relatively the lowest one.