User's Manual

4) Description on LED of Ethernet Port

Yellow LED: This LED indicates the status of data transmission. After power is supplied, it is on

for the first 4-5 seconds and then it goes off. And it blinks continuously when a user access

NetServer and NetServer transmits data.

Green LED: This LED indicates the status of networking. After power is supplied, it is on for the

first 1-2 seconds, and then it blinks once at every one second as long as the network is connected.

5) Descriptions on DIP Switches

To configure the function of the six coaxial cable ports at the rear of NetServer-6 .

You can configure the relevant channels with each switch.

If you connect two CCTV cameras to Video Inputs and monitor real time video through 1 and 2

channels, place the two DIP switches (marked with No. 1 and 2) at upper position ‘ ON’ and the

others at lower position ‘ OFF’ . If you connect six CCTV cameras to Video Inputs and monitor real

time video through all channels, place all of six DIP switches at upper position ‘ ON’ .

You can view a real-time image only through PC monitor, because NetServer-6 is not supported

Phenomenon of Malfunction

1. Network Malfunction

• Green LED blinks once at every 4 seconds

• Check if Ethernet cable is connected properly or the Network works.

2. Software Malfunction

• Green and yellow LEDs are on, and they blink 6 times rapidly at every 10 seconds.

• This problem is to be solved with A/S program. Contact the dealer from who you bought

NetServer.

• After being on for a second, Green and yellow LEDs blink 6 times rapidly. Then green

LED is on and yellow LED is off.

• This problem is to be solved by re-installing firmware. Visit WebGate’ s Internet homepage

to download the firmware and install it on your NetServer.

2 3 4 5 ON

OFF

7 5

Ω

DIP Switch