User's Manual

(Appendix 2)
Upgrading NetServer-6 Firmware
1. Connect NetServer-6 to a PC
• Directly connect NetServer to a PC with a crossover cable. This connection is recommended.
• Connect NetServer to a PC through a HUB with a direct cable.
* This process can also be done on a remote network. However it is not recommended.
Warning
This process is to upgrade NetServer-6 with a new firmware.
Make sure to complete the whole process, since you begin the process. When the process is
completed, ‘ User Image Upgrade is complete’ message appears. During the process, do not give
physical shock nor disconnect network and power. Otherwise, your NetServer-6 can be damaged
seriously, which may result inappropriate operation or operation failure.
If you failed in upgrading NetServer-6 firmware or NetServer-6 does not operate properly after
successful upgrading process, contact WebGate distributor in your area.