User's Manual

(7) FTP event configuration
Administrator may set sending conditions, image resolution, and file name. Image resolution,
filename, and sending conditions setting methods for FTP are same as that of e-mail.
9) Pan/Tilt/Zoom Configuration
This page is to decide whether to use pan/tilt/zoom control function or not and select which serial
port to use.
(1) Video Channel Se lection
Administrator selects a video channel for the pan/tilt/zoom mechanism. The four channels shown in
the panel are the same as seen on ‘ Video Configuration’ page.
(2) Pan Tilt Function
Administrator defines whether to utilize pan/tilt control function or not.
(3) Zoom Function
Administrator defines whether to utilize zoom control function or not.
(4) Pan Reverse Mode Function
This is to set command reverse direction against to right and left direction control arrows. This
function is useful when PT driver is installed upside down.
(5) Tilt Reverse Mode Function
This is to set command reverse direction against to up and down direction control arrows. This
function is useful when PT driver is installed upside down.
Transmission Performance of E-mail and FTP
• NetServer sends once in five minutes at most when administrator configures NetServer to
send e-mail periodically. If there is no restriction in sending e-mail, NetServer may cause a
serious problem to the recipient’ s mail server. However there is no limit in sending e-mails
under MD or sensor activated situation.
• With FTP function, there is no limit. And if the periodic sending menu is set as zero(0)
,
NetServer transmits files at its best performance.
• With FTP function, if the interval between two events is within 2 seconds, the secon
d
event may be neglected. After image transmission, if the second event happens within 3
seconds, the second image file may not be transmitted at all.
• With e-mail function, if the interval between two events is within 3 seconds, the second
image file may not be transmitted at all.