User's Manual

8) Application Configuration
This page is to configure e-mail and file sending functions.
(1) Select Video Channel
It is to select a video channel for configuration.
(2) Recipient E-mail Address
This is to designate a person to receive E-mail.
(3) Sender’ s E-mail Address
This is to put a person’ s e-mail address that is considered as the e-mail sender.
The e-mail sender can be a person who should take care of the situation when events occur. E-mail
will be delivered to a person who is defined as a recipient in the blank of ‘ E-Mail Recipient’ . The
person who received e-mail can send a message of countermove to a person who is defined as an
e-mail sender. Actually, NetServer sends E-mail, but it is no use sending E-mail back to NetServer.
So a person can be designated to receive counter e-mail.
Another important function of this menu is to avoid a problem that the e-mail is blocked from
e-mail server. Some e-mail servers don’ t receive an e-mail that does not have its valid domain name
such as [e-mail]. It is because there are a lot of junk e-mails. So NetServer and other
devices that do not have their valid domain names or only have their IP addresses can’ t send e-mails.
To avoid this problem, NetServer has the menu to put sender’ s e-mail address. The default value is
invalid, so administrator should change the address with valid one. Administrator may put one’ s
e-mail address.
(4) Check E-Mail Options
Relay Mail Server: With the same problem of e-mail blocking, NetServer has a function to relay its
e-mail through an available e-mail server so that e-mail can have the relay server’ s domain name.
After activating ‘ User Relay Mail Server’ menu, key in a server’ s domain name such as
‘@abcdefg.com’ . To use relay mail server function, don’ t use the default value. The e-mail server of
default value is invalid.
Content-Transfer-Type : It is to define e-mail format. E-mail servers support ‘ Base64’ format in
common, but some servers not. In the case, select the format as ‘ Quoted Printable ’ .
(5) E-Mail Event Configuration
Event source : Administrator should define the triggering event for E-mail delivery among MD
(motion detection), sensor 1, sensor 2, sensor 3, sensor 4, sensor 5, and sensor 6. If administrator
clicks on sensor1, e-mail is sent when the sensor1 detects events. (To utilize sensor input detection,
a sensor should be connected to NetServer.) If administrator clicks on periodic sending, e-mail is
sent periodically every preset time. The interval may be modified.
File name : Administrator can name the image files by one of three methods: date & time
(DATETIME; e.g. IMG-CH00-2001030-223031.eye), serial number (SEQNUM; e.g.