User's Manual

key in the assigned pin number to see image after accessing NetServer image viewers. Encryption
PIN (number or character) should be consisted in 9 bytes. 9 bytes are equal to 9 English characters.
‘ Security Configuration’ is a double -checking function to control accessibility, utilizing ‘ User
Account Configuration’ at the same time.
7) Video Configuration
This page is to configure every channel with various conditions.
(1) Video Channel Selection
To select which video channel to configure. In the list, there are 6 video channels.
(2) Video Channel State Control
It is to determine which channels will be enabled to send image signals to the image viewer. If a
channel with an external source is disabled, no image will appear in the image viewer. However, if a
channel without an external source is enabled, the overall transmission speed will go down and no
image will appear. To view an image from an external source, the channel with the source must be
enabled.
(3) Camera Color Type
It is to define whether images from a camera are color or Black/White (B/W). This will not change
a camera’ s original character (color cameras can be viewed in B/W or color, but they are still
“color” cameras). Rather, this is to help define external cameras, and provide information to
NetServer.
(4) Video Signal Type
It is to define whether the signals of external CCTV cameras are ‘ NTSC’ or ‘ PAL’ .
(5) Camera Installation Angle
NetServer can always show images in right angle regardless of camera’ s installation position. If
camera is located on the wall upside down, user can adjust image angel by selecting ’ 90 deg.’ or
‘ 270 deg.’