User's Manual

(1) Auto IP Registration Function
Administrator may register one’ s NetServer by enabling ‘ Auto IP Registration Function’ .
Registration process is that NetServer detects IP addresses from DHCP server and informs the
detected IP addresses to dynamic IP registration server. And the server updates already registered
information with new one. Please keep in mind that user has to enable ‘ DHCP Client Protocol’ at
‘Network Configuration’ page to have NetServer get dynamic IP addresses automatically, when
NetServer is installed on a network of dynamic IP address. With ‘ Auto IP Registration Function’
menu, a NetServer of fixed IP address can also be registered on the list.
(2) Registration Server Address
This is to configure a server address for registration. To manage the registration server(WRS
Front-End) for Dynamic IP registration personally, you should install proper S/W, developed by
Philips Inc. If you do not run a server for IP registration personally, keep the server’ s name as
default figure (NetServer.to).
(3) Registration Interval
Dynamic IP addresses are commonly used with xDSL, ISDN or Cable Modem lines. In order to
maintain continuous connectivity, user should reset the ‘ Registration Interval’ at a shorter time
interval than the default value. If the registered IP information on the dynamic IP registration server
is to be changed, some user may not access the NetServer.
(4) Add Public List
There are two registration systems. One is to register on a public list and the other is on a private list.
(Please refer to Article 5) ‘ How to find registered NetServer in NetServer Internet homepage’ for
more detailed information.)
• Public List: This list is open to anyone who accesses NetServer Internet homepage
(www.NetServer.to
).
• Private List: This list is not seen to anyone. Even the owner of a NetServer can’ t get the
information on one’ s NetServer without viewing information on other’ s NetServer.
(5) Access Token
Access token is a password and it is used when you register your own NetServer on a list ‘ User’ s
NetServer’ out of all NetServers on WRS(NetServer Registration Server). Please refer to Article 5)
‘ How to find a registered NetServer in NetServer Internet homepage’ for more detailed information.
Private List and Access Token
You should set the access token if you configure your NetServer to register its information
on a private list at NetServer Internet homepage (www.NetServer.to
). Otherwise you cannot
access the private list nor find the information on your NetServer.
Access token is to be set 9 bytes. 9 bytes are equal to 9 English characters.