User's Manual

VII. Configuring Administrator’ s Condition at NetServer-6 Homepage
This page is for administrator. Administrator may control operating status remotely. This page can
be accessed through Setup program by clicking ‘ Start Configuration’ button.
1. Administrator Login
1) Accessing through setup program
Select NetServer by clicking on the MAC address or IP address. Then type in the administrator’ s ID
and password (Default ID and password are ‘ admin’ ), and click “ Start Configuration” button. The
setup program automatically connects to the Admin page of NetServer Homepage. (For more
detailed information how to access the page through Setup program, refer to Chapter V ‘ Assigning
IP address and Configuring Administrator’ s Condition’ )
2) Accessing through Web browser
On Web browser, a user may access NetServer login page with its IP
address. In the login page, a user may key in administrator’ s ID and
password or a normal user’ s ID and password. With any of ID and
password, the user may access real time image viewer page.
However administrator can monitor and control real time image
viewer with administrator’ s authority. And a normal user may monitor
and control the viewer page with assigned authority. If a normal user
goes to administration page, one should pass login page again to key
in administrator’ s ID and password while administrator may access
the administration page directly.
Both default administrator’ s ID and password are set as ‘ admin’ , and administrator and users
accounts (ID and password) are to be changed in administration page. But each ID and password
must be composed within 9 bytes. (e.g. 9 English letters)
In the administration page, there are 12 sub-pages where to configure NetServer operating
conditions. It is very important to configure the conditions properly to utilize NetServer well. The
last menu ‘ Goto Viewer Page’ is to go back to real time image viewer.