User's Manual

3) Real time monitoring through Server Push Viewer

If NetServer is installed on a network where firewall is, you may access NetServer through

server-push viewer to monitor real-time images. If you have information on the network such as

which port is block with firewall, you may access with default viewer by changing Web TCP port

or video TCP port. For changing TCP port, please refer to Chapter VII ‘ Configuring A

dministrator’ s Configuration at Homepage’ .

On server-push viewer, some functions such as ‘ Progressive Mode’ image transmission, ‘ Image

Quality’ control, and ‘ Quality Box’ creation menus out of image control and ‘ Preset’ ,‘ Auto Focus’ ,

and ‘ Focus Sensitivity’ control out of PTZ control are not supported. Other functions are same as

that of default viewer.

(1) Image Control

‘ Progressive Mode’ image transmission menu is not supported.

Resolution

Select the level of resolution from 5 levels (720x486, 720x243, 360x243, 180x121, 90x60).

Higher-resolution images are larger file sizes and are transmitted at slower speed.

Frame Rate

Control image transmission speed from 5 levels (fastest, 10fps, 5fps, 3fps, 1fps). “Fastest,” will

receive images at the fastest speed possible within the network environment. The transmission

speed is dependent on the network line’ s capacity and user PC’ s performance.

(2) Camera

Select cameras to monitor. User may select one specific camera to monitor real-time image.

(

)

(2)

(3)

(

)