User's Manual

Expansion
Expansion enlarges the image from 1X to 4X. However, expansion (2X to 4X) does not increase
image’ s resolution, hence the clarity of an expanded image will not be as good as the original.
Frame rate
To control image transmission speed. “Fastest,” will receive images at the fastest speed possible
within the network environment. The transmission speed is dependent on the network line’ s
capacity and user PC’s performance. NetServer can transmit up to 30 frames per second, but total
frames transmitted by all 6 channels cannot surpass the maximum rate of 30 fps.
(3) Camera selection
Select cameras to monitor. User may select one specific camera or all 6 cameras.
(4) Transmission Control
Gray Mode On
Images are displayed in black and white. Images can be transmitted at a higher speed under gray
mode.
Single Shot ModeOn
When this button is clicked, one frame of image is reproduced. Therefore, no other images may be
viewed.
Channel Rotate Mode On
Images are viewed one after another as channel number. It may be configured by second.
(5) Play Control
Pan/Tilt
To move the direction of external camera to where to want to see.
Zoom
To zoom the image in and out.
Focus
To control and optimize the image’ s focus.
Accel. Rate
To control the moving speed of the Pan / Tilt mechanism. There are three settings, denoted by the
small graphic located between the “+” and “ —“ signs. “Accel.” does not control zooming speed.
This can be adjusted with the mouse. By clicking the right mouse button on the image, a pop-menu
with five options will appear. The “Focus Sensitivity” controls zooming speed from level 1 to 10.
Play/Stop: NetServer generates and transfers the real-time images as soon as it is accessed. To stop
transferring images, click the “Stop” button. To resume transfer, click “ Play” button.