User's Manual

VI. Accessing NetServer-6 Homepage & Monitoring Real-time Image
After assigning NetServer an IP address, the NetServer can be configured within its self - contained
homepage through any standard Web browser on a local network. However access to its Homepage
by a remote network is not possible until gateway address, subnet mask, and broadcast address
have been properly assigned.
1. Starting Web browser
Start the web browser and enter the NetServer IP address. This will access the NetServer login
homepage.
• Example
http://200.243.232.178/
NetServer can support up to 100 users simultaneous ly. If a person tries to access NetServer as the
101
st
user, no image will be received, and a counter message in the upper right side of homepage
will be read ‘ Connected Client#: 101’ .
2. Login page
1) ID and password
The login page allows only registered NetServer users to view images from NetServer. To connect
to NetServer and view real-time images, follow the login procedures.
Type In the user’ s ID and password to access the image viewing screen. To access the “Admin
page” directly and configure administrator’ s conditions , type in the administrator’ s ID and
password.
The default name and password for the user is “guest.” The default Admin username and password
is “admin.” Both may be changed at the Admin page, but neither the ID nor password can be more
than nine characters long.