User's Manual

1. Connecting NetServer-6 to a PC
1) Connecting NetServer-6 on Internet or LAN
Use the direct cable (white colored one) to connect NetServer-6 to Internet or LAN. With this
connection, remote users will not be able to access NetServer until local user configures
NetServer’ s network setting.
2) Connecting NetServer-6 to a PC
Use the crossover cable (red colored one) to directly connect NetServer-6 to a PC. This
connection is to be used to configure NetServer.
IP Address Assigning Methods
 With setup program
• Assemble and place NetServer.
• Assign IP address to NetServer using setup program on local network.
• Access NetServer through Web browser with the IP address and configure user’ s condition
and administrator’ s condition.
• If it is impossible to assign IP address with setup program, try it with ARP command.
 With ARP command
• Assemble and place NetServer.
• Assign IP address using ARP command on local network.
• Access NetServer through Web browser with the IP address and configure user’ s condition
and administrator’ s condition.