User's Manual

(Appendix 2)
Upgrading NetServer-1Firmware
1. Connect NetServer-1to a PC.
• Directly connecting NetServer to a PC with a crossover cable. This connection is recommended.
• Connecting NetServer to a PC through a HUB with direct cable.
* You may also do the process on remote network.
Warning
This process is to upgrade NetServer-1with a new firmware.
Make sure to complete the whole process, since you begin the process. When the process is
completed, ‘User Image Upgrade is complete’ message appears. During the process, do not give
physical shock nor disconnect network and power. Otherwise, your NetServer-1can be
damaged seriously, which may result inappropriate operation or operation failure.
If you failed in upgrading NetServer-1firmware or NetServer-1does not operate properly after
successful upgrading process, contact WGI distributor in your area.
Crossover cable