User's Manual

Audio Device
This protocol is for NetServer A10, which is an audio transmission device connected to
NetServer-1.
Control Parameters
With listed protocols of Philips, Pelco, Sensormatic and VT, you may also configure its control
parameters such as ‘Baud Rate’, ‘Stop Bits’, ‘Data Bits’, and ‘Parity Check’ according to connected
dome camera settings.
Manual Setting
If your mechanism doesn’t use any of already listed protocols, you may define the protocol
manually by selecting ‘Manual Setting’ and set parameters through ‘Control Parameters’ and ‘PTZ
CMD’ menus. For detailed information, please refer to following explanation.