User's Manual

Mode
There are three modes like ‘Normal Mode’, ‘Swing Mode’, and ‘Group Mode’.
• Under normal mode, user may control PTZ mechanism of a dome camera with corresponding
buttons in control panel. If you activate ‘Give/Take Mode’ each user is to be permitted to
control the PTZ mechanism for a certain period of time on a first-come-first-served basis.
Administrator may set the time period.
• If swing mode is selected, the connected dome camera swings between the designated points.
Time duration of ‘Wait (some) seconds’ signifies the same meaning that of group mode.
Administrator may set two swing points among 64 preset points that are listed.
• If group mode is selected, the dome camera travels among listed preset point according to the
listed order. Administrator may select a group among 6 groups that are listed.
• With ‘Internal Setting’, you may configure some conditions on the connected a dome camera.
NetServer-1shows proper conditions according to each brand such as Philips, Pelco, and
Sensormatic, etc.
10) Serial Port Configuration
This page is to select a communication protocol among listed ones.
(1) Serial Port Selection
Administrator selects a serial port to configure. NetServer-1has three serial ports. ‘Serial #1’ and
‘Serial #2’ are RS232C interface ports, and ‘Serial #3’ is a RS422/RS485 interface port.
(2) Select Attached Device
Administrator selects a communication protocol that an attached external
device satisfies among already listed protocols. Philips has listed protocols of
Philips, Pelco (P and D), Sensormatic, and Video Technical (VTP 4x).
Administrator may utilize any pan/tilt mechanism that satisfies already listed
protocols.