User's Manual

monitor real-time image.
Below items especially user ID, password, and phone number are used for NetServer to connect ISP
based on standard PPP. Therefore if your PSTN doesn’t need special login script, NetServer dials
up to make PPP connection with these items.
ID/Password: It is to put proper user ID and password for connecting to ISP.
Phone : It is to put telephone number of ISP. If a prefix needs in dialing (e.g. 9), you should mark
tick on the menu and put the prefix the following square.
Disconnect Time : NetServer maintains connection for some while there is action such as sending
e-mail or files. And when the action is stopped, NetServer disconnects after sometime. This is to
configure how long NetServer maintains the connection after any action doesn’t occur. It is to be set
from 1 to 600 seconds. Different to dial-out connection, a user may disconnect from NetServer by
hanging up the phone in dial-in connection.
Login Script: If your telephone line needs special login script to connect ISP,
you should enable ‘Script Enable’ menu and describe the login script. At the
section, there are some commands to describe script.
- End: To end the login process.
- Wait for: To wait for a certain signal.
- Wait for Prompt: To wait for prompt.
- Send: To send after described script.
- Send CR (Carriage Return): It has the same effect to press ‘Enter’ key in the script.
- Send User ID: To send the ID that is described in ‘User ID’ square.
- Send Password: To send the password that is described in ‘Password’ square.
- Delay: To delay for a certain seconds that is described the following square.
Administrator should describe a proper script for
one’s network with provided commands. You may
get the script from your PC if you use the same ISP
that is connected through PSTN. Here is an
example of describing login script.
4) Dynamic IP registration service for ISDN and xDSL users
This page is to register NetServer on dynamic IP registration server.
If NetServer is installed on a network of dynamic IP address (floating IP address), administrator
should register the NetServer to ‘dynamic IP registration server’ to give simple connectivity to
common users. If not, no one can access the NetServer through Web browser. It is because that no
one knows with which IP address one can access the NetServer.