User's Manual

Therefore it is very important to set a proper name for user to find the NetServer in the dynamic IP
registration list. (For detailed information, refer to ‘Dynamic IP Registration Service for ISDN,
xDSL User’)
(2) Model
By clicking ‘Detailed H/W Information’, you may view the detailed hardware information such as
maximum numbers of channel, serial port, digital input, digital output, etc. The model name is
marked automatically.
(3) Installation Location & Additional Description
The information is shown in the real time image viewer page as well as in a dynamic IP registration
list.
(4) Date & Time
There are three date & time menus. In ‘NetServer Current Date & Time’ panel, the date and time
that is set in NetServer appears. In ‘System (PC) Current Date & Time’ panel, the same date and
time that is set in user’s PC appears. And administrator may set one’s system(PC)’s date and time
into NetServer by clicking ‘Time Synchronization’ button. In ‘Manual Date & Time’ panel, user
may set date and time. And administrator also synchronizes date and time with ‘NetServer Current
Date & Time’ by clicking ‘Time Synchronization’ button.
(5) Administrator’s E-mail Address
In this panel, administrator records one’s e-mail address. If administrator put a ‘contact’ menu of
e-mail communication on real time image viewer page, the linked e-mail address to the ‘contact’
menu is to be synchronized with this. So administrator can keep up e-mail address easily.
(6) Initialize Flash Info
This will initialize almost all the information saved on Flash Memory. However Date & Time,
Model, Serial Number, and IP configuration of “System Configuration”, and Video Signal Type of
“Video Configuration” menus will not be changed.
(7) Rebooting
If NetServer has any problem, administrator can reboot it without adjusting power supply. This
button works as on/off switch.
2) User Configuration
This page is to configure IDs and passwords of an administrator and 5 users.
* Notice for Time Setting *
After setting time and date manually at the System Configuration of Admin
Menu, please don’t reboot NetServer-
1within one minute. If you reboot it
within one minute, your setting would not be applied.