User's Manual

VII. Configuring Administrator’s Condition at ‘Admin’ page
This page is for administrator. Administrator may control operating status remotely. This page can
be accessed through Setup program by clicking ‘Start Configuration’ button.
1. Administrator Login
1) Accessing through setup program
First you click on MAC address or IP address of NetServer to select a certain one. Then you key in
the administrator’s ID and password (Default ID and password are ‘admin’), and click ‘Start
Configuration’ button in turns. When you click ‘Start Configuration’ button, the setup program
automatically connects you to Admin page of NetServer Homepage. (For more detailed information
how to access the page through Setup program, refer to Chapter V ‘Assigning IP address and
Configuring Administrator’s Condition’)
2) Accessing through Web browser
On Web browser, a user may access NetServer login page with its IP address.
In the login page, a user may key in administrator’s ID and password or a
normal user’s ID and password. With any of ID and password, the user may
access real time image viewer page.
However administrator can monitor and control real time image viewer with
administrator’s authority. And a normal user may monitor and control the
viewer page with assigned authority. If a normal user goes to administration
page, one should pass login page again to key in administrator’s ID and
password while administrator may access the administration page directly.
Both default administrator’s ID and password are set as ‘admin’, and
administrator and users accounts (ID and password) are to be changed in
administration page. But each ID and password must be composed within 9
bytes. (e.g. 9 English letters)
In the administration page, there are 12 sub-pages where to configure NetServer operating
conditions. It is very important to configure the conditions properly to utilize NetServer well. The
last menu ‘Goto Viewer Page’ is to go back to real time image viewer.
2. Configuring Administrator’s Condition at Homepage
1) System Configuration
This page is to set name, date & time, location, and description of one’s NetServer. Model, serial
number, and software version appear automatically.
(1) NetServer Name
The name is to be used to register the NetServer on a certain server, if you use dynamic IP address.