User's Manual

(2) Pan/Tilt
In the center of the control panel, there is a plotted space with 4 arrows of up, down, left and right
directions. This is to control pan and tilt mechanism of a dome camera with the mouse. By placing
the mouse cursor on the panel and clicking the left button of a mouse at a certain point of the panel,
a dome camera pans and tilts.
• 4 four arrows: They show corresponding directions of tilting up and down, and panning left and
right.
• Each small square: It signifies the combination of degree and speed of panning and tilting.
If you place the mouse cursor on a right-top square and click the left button, a dome camera pans
and tilts at an angle of 45 degrees right-up direction at the highest speed. If you place the mouse
cursor at the end of right direction arrow, a dome camera pans to the right at the highest speed.
(3) Zoom (W/T)
You may zoom in (W: Wide) and zoom out (T: Tele).
(4) Auto Focus
Basically, a dome camera has auto-focus function and it focuses an object automatically. A new
object in the view, however, may not be focused. In the case ‘Auto Focus’ button is used to send
commands to focus automatically to all objects that appear in the view newly. This button is
activated when you click on the button, and it marked in blue. And it is deactivated by clicking once
again on the button. However, this function may burden to a dome camera (especially to integrated
zoom mechanism) when there are a lot of new object in the view.
(5) Manual Focus (N/F)
You may control zoom mechanism with near (N) and far (F) buttons. This is to optimize image’s
focus. Focusing sensitivity is set with ‘Focus Sensitivity’ in pop-up menu as well as in
administration page.
3) Convenient pop-up menu
A small window of 5 menus appears when you click the right button of the mouse. However only
users who are permitted can utilize the functions such as ‘Quality Box’, ‘Focus Sensitivity’, and
‘Image Quality’. ‘Image Info’ and ‘Save File As’ menus are permitted to any user. And the results
of the four functions except ‘Save As File’ are to be affected in every image that is transmitted to all
users. (For detailed information, refer to ‘User account management’ in Chapter VII). And in server
push viewer, only ‘Image Info’ and ‘Save As File’ menus are supported.