User's Manual

(1) Gray Mode
If you choose this mode, the images are displayed in black and white. And, you can view the images
transmitted faster than in color image. By click again the button, the function is released.
(2) Progressive Mode
In the case of ‘Progressive Mode’ on, every image is regenerated from low to high resolution. In
other words, an image is reproduced from vague to clear for user to see what is happening and later
one may detect exact things. This function is useful when you use a low speed network, because it
reduces waiting time. By click again the button, the function is released.
(3) Single Shot Mode
When this button is clicked, one frame of image is reproduced. Therefore, it is stopped transmitting
further image. To resume transmitting real-time images, click the button again.
(4) Resolution
You may select a level of resolution among 3 levels (360x243, 180x121, 90x60). High-resolution
image is big, and its transmission speed is slow. You may monitor 720x486 resolution images
through ‘720x486 Viewer’.
(5) Frame rate
You may choose image transmission speed. If you choose ‘Fastest’, you can get images at the
fastest speed under your network environment. The transmission speed depends much on network
line’s capacity and user PC’s performance. NetServer transmits maximum 30 frames image per
second.
2) Integrated PTZ mechanism control
This is to control integrated PTZ mechanism of a dome camera. The control panel is deactivated at
first. And it is to be activated when a user click on ‘Take Control’ button.
(1) Take Control / Give Control
This is to get power of controlling PTZ mechanism of the connected dome camera. A user who is
permitted to control PTZ mechanism may get the power by clicking ‘Take Control’ button.
Administrator may permit or deny a certain user controlling PTZ mechanism.
Administrator may also restrict the time for controlling PTZ mechanism. If the time is restricted as
60 seconds, any user may control the mechanism for 60 seconds and then the panel becomes
deactivated. There is a counter to show remained time to control. If a user doesn’t get the control
power at the moment because of other users, one may also see a counter that shows remained time
until when to get the power. Different to normal users, administrator can get control power anytime
without time restriction.
When the user gets the power, the button is toggled into ‘Give Control’. During the assigned time, a
user may abandon the control power.