User's Manual

3) Verifying Installation

After successfully completing the above procedures, the following message (or similar) will appear

on the screen:

Request timed out

Reply from 200.243.232.178: bytes=32 time=2ms TTL=255

Ping statistics for 200.243.232.178:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milliseconds:

Minimum = 1ms, Maximum = 2ms, Average = 1ms

If the above “ping” reply does not appear, press 'F3' and 'Enter' keys. Normally “Request timed out”

messages appear 7 times before replying properly.

Once the above “ping” reply appears press <Ctrl>+<C> keys to make it stop.

When the “ping” reply stops, data loss may range from 0% to 99%. This is normal. If the statistic

shows ‘100% loss’, check the following criterions: (a) network line and connection status are stable;

(b) IP address assigned to NetServer is available; (c) PC and NetServer have the same local network

IP address. Same local IP address of C grade network means that first 3 sets of numbers are the

same but the fourth set is different. For example 192.168.1.2 and 192.168.1.3 are in the same local

network. (If there is a ‘Network Mask’ on the network, this can be an exception. For detailed

information on IP, refer to appendix 3)