User's Manual

To change the IP address, enter the Admin’s password
and click “Change IP Addr.” Enter the new IP address
and click “OK.”
The “Reboot” button will reboot the NetServer. This process takes 10-20 seconds.
2) Configuring Administrator’s Conditions
To access the NetServer’s Administrator’s Page from the Setup Menu, enter the admin.’s password
and click the “Start Configuration” button. (For more detailed information, refer to Chapter VII
“Configuring Administrator’s Condition at Homepage”)
3. Assigning IP Address with ARP command
1) Using ARP in Windows 98 and NT
When using NetServer with Windows 98 and Windows NT, follow the steps below.
• Open a DOS window and type the following commands.
arp -s <NetServer IP address> <NetServer Ethernet address>
ping -t <NetServer IP address>
• Example
arp -s 192.168.1.3 00-40-8c-10-00-86
ping -t 192.168.1.3
2) Using ARP in Windows 95
When using NetServer with Windows 95, follow the steps below.
• Open a DOS window and type the following commands.
arp -s <NetServer IP add.> <NetServer Ethernet add.> <my PC IP add.>
ping <NetServer IP address>
• Example
arp -s 192.168.1.3 00-40-8c-10-00-86 192.168.1.2
ping 192.168.1.3