User's Manual

1. Connecting NetServer-1to a PC
1) Connecting NetServer-1on Internet or LAN
You may use direct cable (white colored one) to connect NetServer on Internet or LAN. Though
you connect NetServer as follows, a remote user may not access NetServer before you configure its
network setting properly.
2) Connecting NetServer-1to a PC.
You may use crossover cable (red colored one) to directly connect NetServer to a PC. This
connection is just to configure NetServer.
* IP Address Assigning Methods *
• With setup program
-. Assemble and place NetServer
-. Assign IP address to NetServer using setup program on local network.
-. Access NetServer through Web browser with the IP address and configure user’
s condition
and administrator’s condition.
-. If it is impossible to assign IP address with setup program, try it with ARP command
• With ARP command
-. Assemble and place NetServer
-. Assign IP address using ARP command on local network
-. Access NetServer through Web browser with the IP address and configure user’
s condition
and administrator’s condition.