User's Manual

5. Level Control Stop

command id : 0x03

6. Level Control With ON/OFF

command id : 0x04

level : 0x00 (by user)

transition time : 0x0000 (by user)

7. Level Control Move Mode With ON/OFF

command id : 0x05

movemode : 0x01 (turn on) , 0x00 (turn off)

rate : 0x0A

8. Level Control Step With ON/OFF

command id : 0x06

stepmode : 0x00 (turn on one step) , 0x01 (turn off one step)

setpsize : 0x0A (by user)

transition time : 0x0000 (by user)

9. Level Control Stop With ON/OFF

command id : 0x07

Note: In level control cluster, all with on/off command can control PAD06 without

relay on/off, but the eithers command only control when relay on.

Over The Air (OTA) Firmware Update

The device support the Zigbee firmware update via OTA.

Before starting the procedure, please remove the front cover of the

device. Otherwise the hardware check will be failed.

Choosing a Suitable Location

Do not locate the dimmer facing direct sunlight, humid or dusty place.

The suitable ambient temperature for the Switch is 0°C~40°C.

Do not locate the dimmer where exists combustible substances or any source of

heat, e.g. fires, radiators, boiler etc.

After putting it into use, the body of dimmer will become a little bit hot of which

phenomenon is normal.