User`s manual

EN - 7

01/2012

PART 3: INSTALLATION

Transport and unpacking

If the appliance is transported in a horizontal position the oil from the compressor may leak into the cooling

circuit. For this reason, allow the appliance to rest in a vertical position for 12 hours before turning it on, so that

the oil can  ow back into the compressor.

Remove the external packaging, remove the protective plastic  lm from the surface of the appliance (if used)

and clean the external parts of the appliance with an agent designed for this purpose. Do not use steel wool or

any coarse agents, which could irreparably damage the surface of the appliance. Carefully remove all papers

and adhesive tape from the appliance, door and other parts packed in polystyrene. Remove documents and

accessories from inside the appliance.

The packaging material is recyclable and is marked with a recycling symbol. For disposal follow the local

regulations. Packaging materials (plastic bags, polystyrene parts, etc.) must be kept out of the reach of children,

because they present a possible source of danger.

Carefully inspect the appliance. If you discover any defects, stop the installation and contact the vendor.

Installing the door handle

1. First remove the seal from the internal door area and two holes will appear.

2. Attach the door handle using bolts, washers and a screwdriver. Screw in properly.

3. Reattach the seal.

Door frame

Handle

Bolt

Seal

Flat washer

Operating conditions

Proper operation of the appliance is guaranteed only if the following conditions are met:

• The temperature in the room where the appliance is located conforms to the climate class stated on the

appliance's rating label.

• Maximum ambient relative humidity: 90%.

• The appliance must be placed at a su cient distance from heat sources (e.g. baking ovens, central heating,

direct sunlight, etc.).

• The appliance must be located in such a place that it is protected against the e ects of weather.

• Regular maintenance is performed according to the instructions in this user's manual.

• The ventilation openings in the cover of the appliance must not be covered by anything.

• Correct installation (e.g. levelling, the capacity of the system corresponds to the speci cations on the

rating label of the appliance).