User`s manual

EN - 14
01/2012
Copyright © 2012, Fast ČR, a. s.
PART 4: CONTROLS
Turning on / o
The appliance will turn on automatically after the power cord is connected to a power socket.
Press and hold down the On / O button for 10 seconds to turn the appliance on/o .
The On / O button will work even when the lock function is activated on the control panel.
WARNING:
To prevent damaging the compressor, after turning o the appliance wait at least 5 minutes before
turning it on again.
Locking / unlocking the control panel
To unlock the control panel press and hold down the On / O button and the internal lighting button for
3 seconds. A sound will be made.
The control panel will automatically lock itself after 10 seconds of inactivity. A sound will be made indicating
that the lock is activated.
No button will be active in the locked mode, except for On / O .
Turning the internal lighting on / o
With the control panel unlocked, press the internal lighting button to turn the internal lighting on / o .
The internal area will remain lit until you press the internal lighting button.
Display
The display shows the set temperature. If you change the temperature, the temperature inside the appliance
will change after approximately 10 seconds.
If the temperature sensor is out of order, the display will show "HH" or "LL" instead of digits and a sound will be
made. If this occurs the appliance can maintain its temperature using the compressor and fan.
WARNING:
To prevent the stored wine from spoiling, it is necessary to regularly check the appliance and in the
event of a malfunction to contact an authorised service centre. The appliance is not able to maintain
temperature by means of the compressor and fan for an extended period of time.
Setting the temperature
• The temperature may be set in the range 5 – 22 °C.
• To set the temperature, repeatedly press the temperature increase / decrease buttons.
• When the temperature increase / decrease button is  rst pressed the previously set temperature is recalled.
If the appliance is turned on after an interruption to the power supply, the previous temperature does not
exist and it will be replaced by the default temperature of 12 °C.
• Press the temperature increase / decrease buttons once to increase or decrease the temperature by 1 °C.
• The newly set temperature inside the appliance will be shown on the display approximately 10 seconds
after being set.