Manual

Useful Information
Brakes • The brakes work best when the tires are properly inflated.
Always apply both brakes when parking your buggy.
• To brake, push your foot down on the top of each brake. The
spring will force and hold it onto the wheel.
• To release the brake, push your foot hard down on the tab at
the inside end of the brake.
Safety wrist strap • Your buggy is very free wheeling so the safety wrist strap should
be worn at all times.
• Take special care when using your buggy in high winds, when
running, climbing stairs, mounting or dismounting escalators, walking down hills or on rough terrain.
• The snap fastener attaches to the footplate to keep buggy folded
when not in use.
Harness & Breastplate The breastplate is padded and features an adjustable 5-point harness. Always secure your child with the harness. To fasten: • click the 5 buckles into the buckle ends on the breastplate. • adjust each strap for a firm fit. • thread the straps back through the plastic keepers to lock them
in place.
• adjust the crotch strap to exit the rectangle patch at one of 3
angles.
Warning: ensure crotch strap is used with the rectangle patch at all times
Swivel wheel auto-lock • To fix the front wheel: turn the black cap on the housing, to match
the small hole on the underside and the pin. It clicks.
• Set the wheel to trail straight; the lock clicks into place. The wheel
is now fixed.
• Swivel mode: pull the cap outwards and half turn. The black cap
rests on the pin, letting the wheel swivel.
Layback seat • Unzip the gusset inside the sling to recline sleepy children. • This position is not recommended for newborns who need to lie
flat. Use the newborn wings.
• Always zip up when using the newborn wings.
• Place the older/heavier child in the front seat. • Lie the infant in the rear newborn position. • Secure children with adjusted safety harnesses.
Sibling Fitting (carry newborn and toddler)
Important: Never use the doubles bar with the Sibling position. Installation • Put the brakes on. • Zip the rear sling (RS) to the newborn wings (refer newborn
fitting instructions).
• Unzip the main sling (MS); but do not release the snap fastener
at each side at the top of MS.
• Zip each newborn wing to the corresponding zip on MS. Refer
diagram.
• Attach the anti-fly straps (at the front of RS) to the H frame
crossbar, using the ladder locks. Tighten.
• Loop front strap on MS over the footplate. • Thread the anti-fly straps on MS through the eyelets on RS;
secure to the frame (as before), using the ladder locks.
• Attach the sun hood (as before). • Attach the clear plastic back (as required) using snap fasteners.
Note that different snap positions are used for sibling and newborn positions.
• Zip or velcro the hood to the top of the clear back.
Newborn wings onto RS
MS to RS