evolution™ Group 0+I (0-25kg) SUITABLE FOR The product has been approved according to the strictest European safety standards (ECE R 44/04) and is suitable for Group 0+I+11(0-25KG).
The evolution™ complies with requirements applicable in market of sale Introduction Dear parents Thank you very much for purchasing our product. For rights & remedies, refer www.philandteds.com/warranty Please register your purchase through our online warranty registration by visiting: www.philandteds.com/register philandteds.com The function and design of this seat delivers the highest levels of safety and comfort when your child is in this child restraint.
Content Introduction Important Know your car seat 2 3-4 5-6 1. Suitability 7 7 1.1 Certification 2. Use in the vehicle 8-9 8 9 2.1 Use in the vehicle 2.2 With the vehicle's 3-point seatbelt 3. Securing your baby 10-14 3.1 Securing your baby using the baby insert 10 3.2 Five positions of the car seat 11 3.3 How to adjust the belts, headrest and seat positions 11-12 3.4 Securing your baby using the harness 13 3.5 Tightening the harness 3.
Important /03 Important R16 or an equivalent standard. WARNING: Read this instruction manual carefully. The product may be used on either the front or the back seat. WARNING: The correct fitting of the seat belt, along the red marking between the shell and the base of the seat, is of vital importance for the safety of your child. See figure 4-D and 4-G or the sticker on the side of the product. WARNING: For the future use of the seat, it is important that you keep the instruction manual carefully.
Important /04 It is recommended that the car seat should not be used more than 5 years from the date of production. The properties of the products may deteriorate due to, for example, ageing of the plastic and this may not be visible. The moving parts of the car seat should not be lubricated in any way. The baby car seat must not be used without the cover. Please use an original cover, as the cover contributes to the safety of the seat. The seat must be secured with a seat belt, even when not in use.
Know your car seat /05 1. Cover 2. Group II guide hook 3. Shell 4. Belt guard door 5. Hole 6. Base 7. Belt Yoke 8. Hooks for lap belt 9. Lock-off device 10. Upper shaft and lock 11. Shoulder strap connector 12. Lower shaft and lock 13. Group 0+ blue guide hook 14. Flip out leg support 15.
Know your car seat /06 16. Head pillow 17. Belt pads 18. Shoulder belt 19. Cushion 20. Adjusting cover 21. Adjuster belt 22. Positioning handle 23. Adjusting device 24. Buckle pad 25. Buckle 26. Belt slots 27. Belt clip 28. Belt clip slot 29. Buckle clip 30.
Suitability /07 1. Suitability 1.1 Certification The child safety seat has been designed, tested and certified according to the requirements of the European Standard for Child Safety Equipment (ECE R 44/04). The seal of approval E (in a circle) and the approval number are located on the approval label (sticker on the child safety seat). This approval will be invalidated if you make any modifications to the child safety seat. Only the manufacturer is permitted to make modifications to the child safety seat.
Use in the vehicle /08 2. Use in the vehicle DO NOT use on a passenger seat with a front airbag! DO NOT use with a 2-point belt use with a vehicle’s 3-point seatbelt. Danger! An airbag hitting a child safety seat can cause serious injuries to your child, possibly resulting in death. Please observe the regulations applicable to your particular country. Please observe the instructions in your vehicle manual for the use of child seats.
Use in the vehicle /09 2.1 With the vehicle's 3-point seatbelt You can use your child safety seat as follows: 1. The use of a 2-point belt substantially increases the risk of injury to your child in the event of an accident. 2. The safety belt must be approved to ECE R 16 or a comparable standard (see test label on belt with an "E" or "e" in a circle). against the direction of travel yes5) with 2-point belt no1) with 3-point belt yes2) on front passenger seat yes3) 4.
Securing your baby /10 3. Securing your baby 3.1 Securing your baby using the baby insert For the protection of your baby The baby insert gives your baby the necessary support while he or she is still small. The baby insert is used to provide extra comfort for very small babies. Caution! Please use the baby insert attached to this car seat when your baby's weight is less than 9kg. Always secure your baby in the car seat using the harness.
Securing your baby /11 3.2 Five Positions of the Car Seat The car seat can be used in five positions: • Lift the handle under the front of the seat up and pull or push the shell forwards or backwards (3-A). • Release the handle in the required position and push until you hear a distinct click (3-B). • The shoulder harnesses can be set to four heights and must be passed through the holes closest to the shoulders of your child.
Securing your baby /12 • Make sure that the buckle remains fixed to prevent the belts twisting. • Close the belt guard door (3-H), insert the lower shaft in to the seat (3-I) and latch in place. • If you wish to alter the belts from or to the lowest position, place the baby car seat in the sleeping position. • If you wish to alter the belts from or to the second or the third or highest position, place the baby car seat in the sitting position.
Securing your baby /13 3.4 Securing your baby using the harness The car seat can be used in five positions: • Loosen the shoulder belts by pressing the release button and pulling the shoulder belts as far as you can. Note! Do not pull the belt pads (3-J). • Open the belt buckle (3-M), then fix the belts with elastic straps on both sides (3-K). • Put your child comfortably with his/her back against the shell and make sure that there are no toys or other hard objects in the shell (3-L).
Securing your baby /14 3.5 Tightening the harness • The shoulder straps of the car seat are comfortable but firm fit around your child. The shoulder straps are adjusted correctly. The shoulder straps are not twisted. The buckle tongues are engaged in the harness buckle. • Pull the strap end. • • • • Caution! Pull the strap end straight towards you, not upwards or downwards. 3.7 Removing the CuddleMe Baby Insert for children over 5.5 kg Please pay attention to the strap end.
Installation in the vehicle /15 4. Installation in the vehicle Please do not leave your child unattended in the child safety seat in the vehicle. For the protection of all vehicle occupants • In the case of an emergency stop or an accident unsecured persons or objects may cause injury to other vehicle occupants. Please always check that... • The backrests of the vehicle seats are locked (i.e.that a foldable rear seat bench latch is engaged). • All heavy or sharp-edged objects in the vehicle(e.g.
Installation in the vehicle /16 4.1 Installation of Group 0+ for children weight 0-13kg. Children with a body weight of under 9 kg must be secured with this car seat rearward facing. We recommend using the seat rearward facing until your child has reached a body weight of 13kg. Place the seat rearward facing in your car: • Clip out the leg support (4-A). • Pull out the seat reclining handle; at same time pull the seat to release the handle to position 5 (4-B).
Installation in the vehicle /17 4.2 Installation of Group I for children 9-18kg. • Adjust the baby car seat into the sleeping position (3-B). • Take the lower shaft out of the seat, then pull the seat back (4-G). • Install the safety belt through the seat back from the middle of top and fix into the buckle on the car seat (4-H). • The seat will be fixed by the belt in two directions. Route shoulder belt through both lock-off devices, and lap belt through the lower red guides.
Installation in the vehicle /18 4.3 Installation of Group II for children 15-25kg. • Before the installation, please remove the belt system of baby car seat (see section 5.1) (including belt pads, shoulder belt, buckle & crotch strap jacket (4-L). • Put your kid into the baby car seat. Guide car belt through hook (4-M) and then through the hole in the corner of the bottom (4-L). • Pull the car belt through the hole, and insert it into the buckle (4-N). • Tighten car belt.
Care Instructions /19 5. Care Instructions 5.1 Removing the 5-point harness system and cover • Loosen the belts and the belt pads, see fig. 3-C to 3-E under section 3.3 • Loosen the bottom part of the cover and pull the belt clip through the belt clip slot (5-A). • Then pull the buckle clip through the buckle clip slot (5-B). • Loosen the cover all around and also at the release button/positioning handle (5-C).
Care Instructions /20 5.2 Refitting the 5-point harness system and cover • After washing, place the cover on the shell (5-D). • Loosen the bottom part of the cover and pull the belt clip through the belt clip slot (5-E). • Then pull the buckle clip through the buckle clip slot (5-F). • Thread the belts through the belt pads, head pillow, the cover and the shell (5-G).
Care Instructions /21 5.3 Cleaning Please be sure to use only original replacement seat covers, as the seat cover is important to the proper functioning of the system. Replacement seat covers are available from your retailer. The child seat must not be used without the seat cover. The cover can be removed and washed with a mild detergent using the washing machine's cycle for delicate items (30°C). Please observe the instructions on the washing label of the cover.
Care Instructions /22 Make sure that you have the following details to hand: • Serial number underneath. • Model of vehicle and seat on which the baby car seat used. • Age and weight of your child. 5.5 Warranty The warranty period starts from the date of purchase and is valid for a period of 12 months. The warranty is only applicable to the original owner and is not transferable. The warranty is only applicable to products that have not been adapted by the user.
Additional Instruction /23 6. Additional Instruction BS02-BE/SE BS02-BC/SC BS02-BCE/SCE Side Armor gives you more protection against side impact. When you wash the cover, please firstly take off the Side Armor cover. “CuddleMe” is a very cozy and human-oriented designed foam. Please don't wash this foam when cleaning. Owning all of the premium features of “Cuddle Me” and “Side Armor”, brings you to a new level of safety & cosiness.
Notice AU/NZ phil&teds 102-112 Daniell Street Newtown, Wellington 6021 New Zealand / Nouvelle-Zélande. + 64 4 3800 833 EUR phil&teds Europe BV Klavermaten 37C 7472 DD Hof van Twente (Goor) NETHERLANDS / Pays-Bas. + 31 (0) 547 352 727 USA/CAN phil&teds USA Inc 221 Jefferson Street Fort Collins, CO 80524 USA. 1 800 839 4985 1. This is a Universal child restraint. It is approved to Regulation No.44,04 series of amendments, for general use in vehicles and it will fit most, but not all, car seats. 2.
